Utilizing a semi-open impeller to allow larger solid sizes to pass through results in higher efficiency ratings for this chemical pump. The investment cast 316 stainless steel components are engineered to pump all sorts of hazardous materials through this end suction centrifugal pump. The CHEMFLO® 2 Hydraulic chemical pump is offered with a .22 or .37 cubic inch displacement SAE port.
The ChemFlo® 2 hydraulic pumps utilize a semi-open impeller design to allow for passage of larger solid sizes than similar sized enclosed impellers. Several mechanical seal options are available in addition to the standard type 2100 carbon / ceramic / Viton mechanical seal.
ChemFlo® 2 hydraulic pumps are offered with .22 or .37 cubic inch displacement SAE port fitting gerotor type motors for hydraulic flows up to 10 GPM and a maximum pressure of 2600 PSI. An optional case drain allows the motor to be used in series with other hydraulic devises. Some hydraulic motors are bi-rotational.
ChemFlo® 2 hydraulic pumps are offered with .22 or .37 cubic inch displacement gerotor motors for hydraulic flows up to 10 GPM and a maximum pressure of 2600 PSI.
Further expanding the versatility of the ChemFlo® series is the CFB 2 pump, a ChemFlo® 2 in NiBrAl material. All wetted parts are produced in CA 958 nickel aluminum bronze including the drive sleeve to maximize corrosion protection in seawater applications.
SUCTION AND DISCHARGE
1-1/2" x 1" NPT
Agricultural, Commercial, Industrial, Marine, OEM
MATERIALS OF CONSTRUCTION
316 stainless steel, CFB (nickel aluminum bronze)
Up to 150 GPM
Up to 300'
5.25" semi-open, cast 316 stainless steel
Hydraulic motor .22 cu. in, Hydraulic motor .37 cu. in.
Special seal material combinations available (consult factory), Standard carbon / ceramic / Viton
HYDRAULIC SYSTEM PRESSURE
Up to 2600 PSI
Hydraulic motors with flow control
Up to 130
HYDRAULIC FLUID FLOW
Up to 10 GPM
Gerotor, Bi-Rotational, Optional case drain